Installation and Configuration Manual
36
You can enable Manually Open of the camera, through
which you can test the physical wiring of the opening signal
between the camera and the barrier gate. If the barrier is
opened as scheduled after pressing the button, it means
that the wiring is correct.
For the barrier opening of allowlist, firstly check the
physical wiring. If the wiring is correct, check the
configuration of the allowlist data: Whether the license
plate is added and whether the barrier opening permission
is configured and valid. The above parameters are
configured on the allowlist data page of the camera.
You can check the function when testing the camera wiring.
After the vehicle passes through the radar monitoring area,
the barrier closes. Therefore, after the barrier gate is
opened, the vehicle can pass through the anti-smashing
radar to check whether the gate is closed as scheduled.
The key point of the barrier gate is the monitoring of anti-
hit radar, so the simulation should observe the operations
of anti-smashing radar in real time. If the radar can be
monitored and released in real time when the vehicle is in
and out, it means that the radar works normally.
The remote control has been matched with the barrier gate,
and the barrier gate can be opened/closed by remote
control. When there is an error, re-learn the remote control
by referring to the user’s manual of barrier gate.
To Next Page
Loading...
Need help?
General
