Daikin ATXB25C User Manual

18
Care and Cleaning
CAUTION
Before cleaning, be sure to stop the operation and
turn the breaker off.
Units
 Indoor unit and remote controller
1. Wipe them with dry soft cloth.
 Front panel
1. Open the front panel.
• Hold the front panel by the panel tabs
on the both sides and open it.
Panel tab
2. Remove the front panel.
• Slide the front panel to either the left or
right and pulling it toward you.
This will disconnect the front panel
shaft on one side.
• Disconnect the front panel shaft on the
other side in the same manner.
Front
panel shaft
3. Clean the front panel.
• Wipe it with a soft cloth soaked in water.
• Only neutral detergent may be used.
• In case of washing the panel with water, wipe it with dry soft cloth, dry it up in the shade
after washing.
4. Attach the front panel.
• Align the front panel shaft on the left
and right of the front panel with the
slots, then push them all the way in.
• Close the front panel slowly.
(Press the panel at both sides and the
center.)
CAUTION
• Don’t touch the metal parts of the indoor unit. If you touch those parts, this may cause an
injury.
• When removing or attaching the front panel, use a robust and stable stool and watch your
steps carefully.
• When removing or attaching the front panel, support the panel securely with hand to prevent it
from falling.
• For cleaning, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile
oils, polishing compound, scrubbing brushes, nor other hand stuff.
• After cleaning, make sure that the front panel is securely xed.

Daikin ATXB25C Specifications

General

Brand	Daikin
Model	ATXB25C
Category	Air Conditioner
Language	English