11
Read First
Preparation Before Operation
WARNING
Be sure to stop the operation and remove the power supply
plug before installation. (Electric shock or injury may result)
3
Insert the power supply plug into the power socket
• The basic sensitivity of the odor sensor will be determined by odor
levels in the rst 1 minute (approx.) after the power supply plug is
inserted every time.
Insert the power supply plug when the air is clean (odor-free).
Power supply plug
Power socket
2
Attaching the carbon lter
1. Remove the carbon lter unit from the main
unit.
Hold the lever of the carbon lter unit and the grip,
and pull it out.
Lever
Grip
Hooks
Fixed
parts
Bottom side
Top side
Bottom side
Carbon lter
unit
2. Remove the carbon lter from the bag.
• The carbon lter has no front or back.
Carbon lter
Wear gloves when
working.
(Dust from the carbon
lter may make your
hands dirty.)
• Observe local waste separation rules when
disposing of the carbon lter bag and desiccant.
3. Turn the carbon lter unit over and attach
the carbon lter.
1
Set the carbon lter under the xed parts (3places).
Carbon lter
Fixed parts
2
While pushing the hooks up, set the carbon lter
under the 2 hooks.
Hooks
Push up the hooks on the
carbon lter unit.
Securely attach the lter with the hooks.
4.
Install the carbon lter unit into the main unit.
Press until a catching
sound is heard
•
When starting operation, if a notication tone sounds
and the odor sensor lamp blinks, the carbon lter unit
and the carbon lter are not properly installed.
Re-install the carbon lter unit and the carbon lter.
3 long
beeps
To Next Page
Loading...
Need help?
General
