Daikin MCB50YSAU User Manual

17
Maintenance
Maintenance
WARNING
Be sure to stop operation and unplug the power supply plug before
performing maintenance. (Electric shock or injury may result)
(Left-side)
(Front)
(Right-
side)
Unit/Outow grill
If dirt becomes an issue Wipe
• Wipe up dirt with a soft damp cloth.
• If dirt buildup is severe, wet a cloth with kitchen-use neutral detergent
and wipe up the dirt.
• Do not use a hard brush, etc. (Damage may result)
Dust/Particle sensor
If dust builds up
Vacuum cleaner
1
Remove the pre-lter (left-
side).
2
Vacuum off any dust using a
vacuum cleaner crevice tool or
similar.
About 1 time every 3 months
Wipe
1
Remove pre-lter (left-side) and
the cover of the air intake for the
sensor.
2
Because it is difcult to see even
when illuminated with a light,
lightly rub with a dry cotton swab
along the left-side of the inside.
Vacuum off any dust around the area
using a vacuum cleaner crevice tool or
similar.
Lens
3
After cleaning, be sure to attach
the cover securely.
(Malfunction may result)
1
Remove
hook
and pull
toward
you
Air intake for sensor
Pre-lter (front, left-side, right-side)
About 1 time every 2 months
Vacuum cleaner
Wash with water
• After removing any dust using a
vacuum cleaner, remove and
wash the lter with water, then
dry thoroughly in the shade.
• Use a soft brush to clean the
spaces between the slats.
Attention
• Do not use a cotton swab or
hard scrubbing brush.
(Partial damage to the lter may result)
• Do not apply too much force.
(Partial damage to the lter and
scratching may result)
How to remove
Hold the
indentation of the
pre-lter and pull it
toward you to
remove it.
1
Put your thumb
on the unit and
hold the end of
the pre-lter.
2
Pull it toward
you to remove it.
How to attach
Insert the hooks
(2places) into
the unit, then
press until a
catching sound
is heard.
Hooks
(2places)
Insert the hook
(1place) into the
unit.
Press both ends
to securely
attach.
Hook (1 place)
Viewed from above
Reverse side
• If dirt buildup is severe, leave the
part soaking in lukewarm or room
temperature water mixed with
kitchen-use neutral detergent,
then throughly rinse so that no
detergent remains and leave in
the shade until completely dry.
UV unit (inside)
The UV unit cannot be cleaned.*
• Do not touch the UV
unit.
(Malfunction may
result)
* Cleaning is not required,
but if dirt becomes an
issue, it can be
replaced.
Contact your dealer or
the customer service
center.
Attention
• Please observe to prevent discoloration and
deformation.
• If detergent was used, wipe thoroughly so that
no detergent remains.
• When using hot water, keep the temperature
below 104°F (40°C).
• Do not dry in direct sunlight.
• Do not dry with a hairdryer.
• Do not expose to re.
• When using a vacuum cleaner, do not impact the
part with the vacuum cleaner.
(Damage may result)
01_EN_3P671617-2A.indd 17 2021/11/22 16:27:38

Daikin MCB50YSAU Specifications

General

Brand	Daikin
Model	MCB50YSAU
Category	Air Cleaner
Language	English