Q: Is it possible to see if UV emission is being performed while the UV function is ON?
A:
For safety, the unit is structured so that UV emission cannot be seen.
Q: The sensitivity of the dust/particle sensor seems to be poor...
A:
If the dust/particle sensor lens is dirty, the sensitivity may become poor, so clean it
regularly.
►
Page 17
In addition, the reaction time of the dust/particle sensor varies depending on the
size of the room.
Adjust in accordance with the Dust/Particle Sensor Sensitivity Setting.
►
Page 15, 16
If the airow rate setting is set to a strong setting like “Turbo”, the responsiveness
of the dust/particle sensor may be poor.
This is not a malfunction because the airow rate is strong and the dust is sucked
into the air inlet before it reaches the dust/particle sensor.
Dust/Particle sensor
Q: Can I clean the dust collection lter?
A:
Maintenance of lter is not possible, but can be replaced. Do not vacuum or
wash with water.
(Reduced performance of the dust collection lter may result)
Replace if dirt buildup is severe.
►
Page 18
Q: The color of the dust collection lter is changing...
A:
The dust collection lter may turn black due to the collection of dust, or turn yellow
or brown due to the UV rays, but this discoloration does not affect the dust
collection performance.
If you are concerned, replace it.
►
Page 18
Q: Can the carbon lter be washed with water?
A:
It cannot be washed with water.
(If you wash it with water, it will lose its shape and you will not be able to use it.)
If you inadvertently washed it with water, replace it.
►
Page 18
Remove the carbon lter unit from the unit and vacuum off dust with a vacuum
cleaner. If odor becomes a problem, expose to airow in a shady place. (Approx.
1day)
If odor and dirt are still an issue even after cleaning, replace it.
►
Page 18
Q: Is continuous operation possible?
A:
It can be operated continuously.
Stop operation regularly and clean it.
To Next Page
Loading...
Need help?
General
