PROGRAM
RUN OFF SET
EveningMorning
MTuWThF
SaSu
Day
Night
HEAT
AUX
COOL
PM
AM
FILTER
SET
20
Calibration
NEXT
Press NEXT
to advance
NEXT
Press NEXT
to advance
NEXT
Press NEXT
to advance
Under normal circumstances it will not be necessary to adjust
the calibration of the temperature sensor. If calibration is
required, please contact a trained HVAC technician to correctly
perform the following procedure.
Enter advanced setup by sliding the Program Switch to SET. When the
clock is flashing, press the NEXT button for 5 seconds. Do not release
the button until this screen appears.
When the Cycles Per Hour is
flashing, press and hold the
NEXT button until this screen
appears.
Press the NEXT button
twice to advance to the
calibration screen.
Slide the Program Switch to OFF or RUN to
return to normal operation.
Adjust the temperature
reading using the WARMER
and COOLER buttons, then
press the NEXT button to
store the new value.
To Next Page
Loading...
Need help?
General
