74 | P a g e
8. BAS INTERFACE
8.1 General
The MicroTechIII controller is available with an exclusive Daikin feature that provides
easy integration with a building automation system (BAS). If the unit is to be tied into a BAS
system, the controller should have been purchased with the correct factory-installed
communication module. The modules can also be added in the field during or after installation.
If an interface module was ordered, one of the following BAS interface installation
manuals was shipped with the unit. Contact your local Daikin sales office fora replacement, if
necessary. This BAS interface can communicate using Modbus protocol or BACnet protocol.
8.2 Modbus protocol
8.2.1 MODBUS Data Points