3.5.4.1 Editing IP and Remote ID settings
Editing the IP and the Remote ID settings is performed in the same
manner.
To edit the IP settings, proceed as follows:
1. Ensure the sender unit is connected.
↳
If the connection of the sender unit has been accidently
interrupted, this will be detected by the meter unit within 5
seconds.
The meter unit will then switch to the «Home» screen and a
corresponding message will be issued.
The «LASER» button and the sender settings menu will no
longer be accessible.
After the interruption has been resolved, the meter unit will
return to the Home screen.
The «LASER» button and the sender settings menu will
become accessible again.
2. Within the «Sender settings» menu, select the «IP settings» item
to enter the «IP settings» menu.
3. Scroll to the desired item (e.g. IP) and press the «SELECT»
button.
↳
The «Set IP» menu opens and the first digit is flashing.
4. Use the «SCROLL» button to move through the digits. When a
digit is marked, it starts flashing.
Use the «INC» button to increment the selected digit by one.
5. Once the last digit is selected, the left-hand button changes
from «SCROLL» to «SET».
6. Press the button to confirm your changes.
↳
The meter unit switches back to the «IP settings» menu.
If no changes have been made, the meter unit switches
directly back to the «IP settings» menu as soon as you scroll
to the last digit.
d&b ArraySight Manual 1.7 en12
To Next Page
Loading...
Need help?
General