What to do if I get a HIGH PRESSURE ERROR on my Danfoss Heat Pump?
If you receive a HIGH PRESSURE ERROR, it means the high pressure switch has tripped, and the compressor has stopped. To address this, acknowledge the alarm by setting the heat pump to operating mode OFF and then back to the desired operating mode.
Why am I getting a MOTOR ERROR on my Danfoss Heat Pump?
A MOTOR ERROR indicates that the overload relay (overcurrent relay) compressor or the overload relay for the outdoor unit fan has been activated. To fix this, acknowledge the alarm by setting the heat pump to operating mode OFF and then back to the desired operating mode.
General| COP (Heating) | 4.5 |
|---|---|
| Refrigerant | R410A |
| Operating Temperature Range (Heating) | -20°C to 35°C |
| Operating Temperature Range (Cooling) | 10°C to 46°C |
| Type | Air to Water Heat Pump |
| Sound Power Level | 55 dB(A) |
| Power Supply | 400V, 3-phase, 50Hz |
To Next Page