Main switch ( -1=Service, 0=OFF, 1=ON,)
Reference displacement oset temperature
Pull down limit temperature
Alarm
Table 31: Alarm
Delay for temp alarm during normal conditions
Delay for temp alarm during pull-down/start up/
defrost
DI1 delay (Time delay for selected DI1 function)
DI2 delay (Time delay for selected DI2 function)
Condenser High alarm limit
Condenser High block limit
Defrost
Table 32: Defrost
Defrost Method (no=None, nAt=Natural, EL = Elec-
tric; gAS=Hot gas)
Defrost stop temperature.
Defrost delay at power up (or DI signal)
Fan start temperature after defrost
Accumulated Compressor runtime to start defrost
(0=OFF)
Defrost on demand (20=OFF)
Defrost delay after pull down cycle
(1)
This option is a default setting in the controller and cannot be changed.
(1)
This option is a default setting in the controller and cannot be changed.
Fan control
Table 33: Fan control
Fan stop evap. Temperature
(1)
This option is a default setting in the controller and cannot be changed.
(1)
This option is a default setting in the controller and cannot be changed.
Electronic refrigeration control, type ERC 21X
© Danfoss | Climate Solutions | 2023.01 BC194286421698en-000901 | 28