Danfoss FC 301 User Manual

3. How to Install
3.1.1. About How to Install
This chapter covers mechanical and electrical installations to and from power terminals and control
card terminals.
Electrical installation of
options is described in the relevant Instruction Manual and Design Guide.
3.1.2. How to Get Started
The FC 300 AutomationDrive is designed for quick installation and is EMC compliant. Just follow
the steps described below.
Read the safety instructions before installing the unit.
Mechanical Installation
• Mechanical mounting
Electrical Installation
• Connection to Line and Protecting
Ground
• Motor connection and cables
• Fuses and circuit breakers
• Control terminals - cables
Quick set-up
• Local Control Panel, LCP
• Automatic Motor Adaptation, AMA
• Programming
Frame size is dependent on enclosure type,
power range and line voltage.
3.1: Diagram showing basic installation including
line power, motor, start/stop key, and potentiom-
eter for speed adjustment.
VLT
®
AutomationDrive FC 300 Instruction
Manual
3. How to Install
MG.33.A9.22 - VLT is a registered Danfoss trademark 13
3

Danfoss FC 301 Specifications

General

Brand	Danfoss
Model	FC 301
Category	Controller
Language	English