User Guide
3. Changing the batteries
When the battery level is low, the alarm bell and battery icon will
ash simultaneously.
If the battery goes at, the system switches automatically to frost
protection mode.
Remove the battery cover and insert two batteries. Ensure that
the batteries are correctly oriented.
Note: Rechargeable batteries must not be used - use only 1.5V AA
alkaline batteries.
4. Temperature control and adjustment
The temperature is usually controlled via
Danfoss Link™ CC, but may be changed at
any time using the thermostat’s buttons.
If this is done, the thermostat sends a
message to Danfoss Link™ CC, instructing
it to synchronise the other thermostats in
the room.
The change only remains in eect until the
next programmed period.
Temperature range 4-28°C.
Press to change
the temperature.
18
19
20
21
26
25
24
23
To Next Page
Loading...
Need help?
General
