34 MG.30.A7.02 - VLT
®
is a registered Danfoss trademark
The following must be programmed:
Function Parameter no. Parameter value
Thermistor on terminal 16 400 Thermistor
Connection examples
Example 3:
START/STOP REVERSING, thermistor built-in motor connected to VLT
®
frequency converter.
Reference: 1 kΩ potentiometer, 0-10 V ~0-100% speed
NB: Screen for control cables must be
connected as described in the chapter on
EMC-correct installation.
All settings are based on factory settings, but
motor data (parameters 103-105) must be set
according to the motor connected
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
