Danfoss VLT 5000 User Manual

Synchronizing controller
68 MG.10.N4.02 - VLT is a registered Danfoss trademark
Parameter 744 Step width: In marker synchronization mode, Offset Parameter 740 is changed
by this value when Terminal 32 or Terminal 33 is activated.
Parameter 745 Slave speed factor: Record the factor by which the slave speed must be
multiplied, so that the desired value is displayed. To calculate the value use
the following formula:
Factor =
valueDisplay
resolutionerSlaveencodN
Set
_*60
_*400*
Example:
resolution 1024 increments, desired display 100 at 1500
1
/
min
Factor =
1500 400 1024
60 100
1
min
.
.
**
*
Inkr
Umdr
= 102400
Parameter 746 Master speed factor: Record the factor by which the master speed must be
multiplied, so that the desired value is displayed. To calculate the value use
the following formula:
Factor =
valueDisplay
resolutionderMasterencoN
Set
_*60
_*400*
Parameter 747 Synchronizing error display factor: Record the factor by which the error must
be multiplied, so that the desired value is displayed. To calculate the value,
use the following formula:
Factor =
valueDisplay
resolutionerSlaveencodN
Set
_*60
_*400*
Store your data settings by means of Store Input (I4) or by changing Parameter 710 to “1”.

Danfoss VLT 5000 Specifications

General

Brand	Danfoss
Model	VLT 5000
Category	Controller
Language	English