Danfoss VLT 5000 User Manual

Synchronizing controller
78 MG.10.N4.02 - VLT is a registered Danfoss trademark
750 Virtual master maximum speed
Factory setting: 25600
1
/
s
Setting range from: 1 to: 2147483647
1
/
s
User setting: __________
1
/
s
751 Marker window slave
Factory setting: 0
Setting range from: 1 to: 2147483647
User setting: __________
752 Marker window master
Factory setting: 0
Setting range from: 1 to: 2147483647
User setting: __________
753 Control source test run (Contr. testrun).
Factory setting: 0
Setting range from: 0 to 1
User setting: __________
754 Control source synchronizing (Contr. synchron).
Factory setting: 0
Setting range from: 0 to 1
User setting: __________
755 Brake on delay (Brake on delay).
Factory setting: 0
Setting range from: 0 to 5000msec.
User setting: __________ msec
756 Brake off delay (Brake off delay).
Factory setting: 0
Setting range from: 0 to 5000msec.
User setting: __________ msec
757 Marker monitor (Marker monitor)
Factory setting: 0
Setting range from 0 to 2
User setting: __________
758 Resync. (Resync)
Factory setting: 0
Setting range from 0 to 1
User setting: __________

Danfoss VLT 5000 Specifications

General

Frequency	50/60 Hz
Output Voltage Range	0-100% of input voltage
Protection Features	Overvoltage, Undervoltage, Overtemperature, Short circuit
Communication Interfaces	RS-485
Ambient Temperature Range	-10°C to +40°C
Enclosure Rating	IP20, IP21, IP55
Input Voltage	200-240V AC, 380-480V AC, 525-600V AC