VLT
®
5000 Series
Safety
175ZA439.21
Warning:
Touching the electrical parts may be fatal - even after the equipment has
been disconnected from mains.
Also make sure that other voltage inputs have been disconnected, such as
external 24 V DC, load-sharing (linkage of DC intermediate circuit), as well
as the motor connection for kinetic back-up.
Using VLT 5001-5006, 200-240 V: wait at least 4 minutes
Using VLT 5008-5052, 200-240 V: wait at least 15 minutes
Using VLT 5001-5006, 380-500 V: wait at least 4 minutes
Using VLT 5008-5062, 380-500 V: wait at least 15 minutes
Using VLT 5072-5302, 380-500 V: wait at least 20 minutes
Using VLT 5352-5552, 380-500 V: wait at least 40 minutes
Using VLT 5001-5005, 525-600 V: wait at least 4 minutes
Using VLT 5006-5022, 525-600 V: wait at least 15 minutes
Using VLT 5027-5062, 525-600 V: wait at least 30 minutes
Using VLT 5042-5352, 525-690 V: wait at least 20 minutes
Using VLT 5402-5602, 525-690 V: wait at least 30 minutes
MG.51.A9.02 - VLT is a registered Danfoss trademark
5
To Next Page
Loading...
Need help?
General