Danfoss VLT FC 100 Series User Manual

3. How to Configure the System
3.1. Configure the DeviceNet Network
All DeviceNet stations that are connected to
the same bus network must have a unique
station address. The DeviceNet address of the
frequency converter can be selected via:
- Hardware switches (default 63)
- Parameter 10-02
MAC ID (default
63)
- Class code 0X03, Instance 1, Attrib-
ute 1
3.1.1. Setting the DeviceNet Address using the Hardware Switches
Setting the DeviceNet Address using the Hardware Switches: Using the hardware switches it is
possible to select an address range from 0-63 (factory setting 63) according to the table below:
Switch
8 7 6 5 4 3 2 1
Address value - - +32 +16 +8 +4 +2 +1
Ex. address 5 - - OFF OFF OFF ON OFF ON
Ex. address 20 - - OFF ON OFF ON OFF OFF
Ex. address 35 - - ON OFF OFF OFF ON ON
NB!
Switch off the power supply before changing the hardware switches.
The address change will come into effect at the next power-up, and can be read in par. 10-02
MAC ID .
3.1.2. Setting the DeviceNet Address via Par. 10-02 MAC ID
The address can be set via par. 10-02 MAC ID if the hardware switches are set to 63 (factory
setting). The address change will come into effect at the next power-up.
3.1.3. Setting the DeviceNet Address with the Object Class Code
0x03, Attribute 1, Instance 1
The address can be set via the DeviceNet object class code 0x03 attribute 1 command if the
hardware switch is set to 63 (factory setting). A new address becomes effective immediately after
the class code 0x03, Instance 1, Attribute 1 command.
FC 100/ 200/ 300 DeviceNet 3. How to Configure the System
MG.33.D3.02 - VLT
®
is a registered Danfoss trademark 19
3

Danfoss VLT FC 100 Series Specifications

General

Brand	Danfoss
Model	VLT FC 100 Series
Category	DC Drives
Language	English