Danfoss VLT FC Series User Manual

3.4.5 Terminal Tightening Torques 26
3.4.6 Input Line Connection 26
3.4.7 Motor Wiring 26
3.4.8 Grounding (Earthing) 27
3.4.9 Control Wiring 27
3.4.10 Serial Communication Bus Connection 28
3.4.11 Programming 28
4 Start Up
29
4.1.1 Inspection Before Start Up 30
4.1.2 Start Up Procedure 31
5 Electromechanical Bypass (EMB) Operation
33
5.1.1 EMB(0) and EMB1 36
5.1.2 EMB Auto Bypass 38
5.1.3 EMB Common Run/Stop 38
5.1.4 EMB Run Permissive 39
5.1.5 EMB Overload 39
5.1.6 EMB Safety Interlock 40
5.1.7 EMB Fire Mode 40
5.1.8 EMB Fault Reporting 40
5.1.9 EMB Switches 41
6 Electronically Controlled Bypass (ECB) Operation
42
6.1.1 Overview 42
6.1.2 Drive Control Terminals 44
6.1.3 ECB Control Card 45
6.1.4 ECB Drive or Bypass Selection 48
6.1.5 ECB Programming 49
6.1.6 ECB Hand/Off/Auto 49
6.1.7 ECB Mode of Operation 50
6.1.8 Bypass Status Word Bit Examples 52
6.1.9 ECB Auto Bypass 52
6.1.10 ECB Run Permissive 53
6.1.11 ECB Overload 53
6.1.12 ECB Safety Interlock 54
6.1.13 ECB Common Run/Stop 54
6.1.14 ECB Advanced Fire Mode 54
6.1.15 ECB Fault Reporting 55
7 Non-bypass Component Functions
56
7.1.1 Power Fusing 56
Contents Option Panel Operating Instructions
2 MG14I102 - VLT
®
is a registered Danfoss trademark

Danfoss VLT FC Series Specifications

General

Brand	Danfoss
Model	VLT FC Series
Category	DC Drives
Language	English