Danfoss VLT Micro Drive FC 51 Series User Manual

6.2.1 Conversion Index
The various attributes of each parameter are displayed in the section Factory Settings . Parameter values are transferred as whole numbers only. Con-
version factors are therefore used to transfer decimals according to the table below.
Example:
Par. 1-24
Motor Current has a conversion index of -2 (i.e. conversion factor of 0.01 according to the table below). To set the parameter to 2.25 A, transfer
the value 225 via Modbus. The Conversion Factor of 0.01 means that the value transferred is multiplied by 0.01 in the drive. The vale 225 transferred on
the bus is thus perceived as 2.25 A in the drive.
Conversion index Conversion factor
2 10
1100
0 1
-1 0.1
-2 0.01
-3 0.001
-4 0.0001
-5 0.00001
Table 6.1: Conversion table
6.2.2 Change during operation
“TRUE” means that the parameter can be changed while the frequency converter is in operation and “FALSE” means that the frequency converter must
be stopped before a change can be made.
6.2.3 2-Set-up
“All set-up”: The parameter can be set individually in each of the two set-ups, i.e. one single parameter can have two different data values.
”1 set-up”: Data value will be the same in both set-ups.
6.2.4 Type
Data Type Description Type
2 Integer 8 Int8
3 Integer 16 Int16
4 Integer 32 Int32
5 Unsigned 8 Uint8
6 Unsigned 16 Uint16
7 Unsigned 32 Uint32
9 Visible string VisibleString
VLT
®
Micro Drive FC 51 Operating Instructions 6 Parameter Overview
MG.02.A4.02 - VLT
®
is a registered Danfoss trademark 45
6

Danfoss VLT Micro Drive FC 51 Series Specifications

General

Brand	Danfoss
Model	VLT Micro Drive FC 51 Series
Category	Media Converter
Language	English