DATACARD
®
SERVICE ANNOUNCEMENT
Modular design –makes it easy to setup printer and laminator and connect cables; each
component (i.e. SD460 printer and SLM (standard lamination module)) may be tested and
serviced separately
Lamination Station- Laminator Station 1 (L1) has single sided lamination capabilities with
option for Laminator Station 2 (L2) which provides the ability to apply two different types of
laminate material to meet the changing needs of the customer; easy to disassemble; LED light on
laminator which shows status (i.e. warming up, up to temperature etc,)
Optional Tactile Impression feature- inline generic impression feature imbedded into the
substrate of a card with optional custom die. Datacard offers five generic impressions and can
customize impressions as well
Debow feature- easy to adjust settings in printer manager
Printer manager- Web-based printer manager is used for printer and laminator configuration
and diagnostics
Easy driver installation- Uses Microsoft Windows 7 & 8 OS driver and is compatible with
Datacard
®
IDWorks
®
software
Unique laminate cores – this prevents the material from being loaded improperly; the SD460
system laminates are not compatible with the SP75 Plus printers
Preventative maintenance- Preventative maintenance is performed by the operator using a
cleaning sleeve and cleaning card; it is recommended under normal operating conditions that the
cleaning sleeve is replaced and a cleaning card is run through the system after 500 cards are
produced. A sticky cleaning card is used to clean the laminator. Both the printer and laminator
cleaning cycles can be initiated via the front LCD panel of the printer.
Service Guidelines
There are several service options for the SD460 system. Service guidelines for each option are
provided below.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
