PowerScan® M8300 Configuration
Quick Reference Guide 9
USING MULTIPLE READERS WITH SAME CRADLE
If you want to use several readers associated with the same cradle, you must first Bind
the cradle with one of the readers (see previously described configuration procedure).
Successive readers
can be associated with the same cradle by following the
configuration procedure substituting the Bind command with Join.
END of procedure.
POWERSCAN
®
M8300/STAR-MODEM™ STAND ALONE SETUP
To configure a PowerScan® M8300 reader to communicate with STAR-Modem™ in
Stand Alone Mode, follow the "PowerScan® M8300/BC-80X0 Stand Alone Setup"
procedure substituting steps 6 and 7 with those below:
END of procedure. YOUR READER IS NOW READY TO READ CODES.
7. Join
Ì$+RN1$-NÎ
The green LED on the PowerScan
®
M8300 will blink: the reader is ready to be
positioned onto the cradle. Complete step 8.
All readers associated with the same cradle must have different addresses.
CAUTION
6. STAR-Modem™ Address
ÌRSRÎ
Read the code above and the four-digit address of the STAR-Modem™.
7. Exit and Save Configuration
Ì$-?Î
To Next Page
Loading...
Need help?
General
