Operating Modes
18 PowerScan™ PD953X
Scan Mode
Motion Aiming Control
This feature configures the ability of the scanner to
Enable/Disable the Aiming system when motion is
detected (Motionix™ motion-sensing technology). Scan
the Enter/Exit Programming bar code above, then either
of the barcodes below.
ENTER/EXIT PROGRAMMING MODE
Scan Mode = Trigger Single
Scan Mode = Trigger Pulse
Multiple
Scan Mode = Trigger Hold Mul-
tiple
Scan Mode = Flashing
Scan Mode = Always On
Scan Mode = Stand Mode
Motion Aiming Control =
Enable
Motion Aiming Control =
Disable
To Next Page
Loading...
Need help?
General
