Pick Mode
12 PowerScan™ PM9500
Motion Aiming Control
This feature configures the ability of the scanner to
Enable/Disable the Aiming system when motion is
detected. Scan the Enter/Exit Programming bar code
above, then either of the bar codes below.
Pick Mode
Pick Mode is a Decoding and Transmission process where
bar codes that are not within the configurable distance
from the center of the aiming pattern are not acknowl-
edged or transmitted to the host. It is active only in Trigger
Single mode. If the scanner switches to a different Read
Mode, Pick Mode is automatically disabled.
♦
Motion Aiming Control =
Enable
Motion Aiming Control =
Disable
This feature is not compatible with Multiple
Labels Reading in a Volume. See the PRG for
more information.
ENTER/EXIT PROGRAMMING MODE
♦
PIck Mode = Disable
Pick Mode = Enable
To Next Page
Loading...
Need help?
General
