Installing the Battery Pack
Quick Reference Guide 3
Installing the Battery Pack
To install, charge and/or do any other action on the bat-
tery, follow the instructions in this manual.
NOTE
To charge the Battery Pack, See “Charging the
Batteries” on page 6.
Datalogic recommends annual replacement of
rechargeable battery packs to ensure maxi-
mum performance.
WARNING
Do not discharge the battery using any device
except for the scanner. When the battery is
used in devices other than the designated
product, it may damage the battery or reduce
its life expectancy. If the device causes an
abnormal current to flow, it may cause the
battery to become hot, explode or ignite and
cause serious injury.
Lithium-ion battery packs may get hot,
explode or ignite and cause serious injury if
exposed to abusive conditions. Be sure to fol-
low the safety warnings that follow:
• Do not place the battery pack in fire or heat.
• Do not connect the positive terminal and neg-
ative terminal of the battery pack to each
other with any metal object (such as wire).
• Do not carry or store the battery pack
together with metal objects.
WARNING
• Do not pierce the battery pack with nails, strike
it with a hammer, step on it or otherwise subject
it to strong impacts or shocks.
• Do not solder directly onto the battery pack.
• Do not expose the battery pack to liquids, or
allow the battery to get wet.
• Do not apply voltages to the battery pack con-
tacts.
In the event the battery pack leaks and the fluid
gets into your eye, do not rub the eye. Rinse well
with water and immediately seek medical care.
If left untreated, the battery fluid could cause
damage to the eye.
To Next Page
Loading...
Need help?
General
