Reading Parameters
26
QUICKSCAN™ QBT/QM2500
READING PARAMETERS
Move the reader toward the target and center the aiming
pattern and illumination system to capture and decode
the image. See "Using the QuickScan™ QBT/QM2500" on
page 11 for more information.
The aiming system will briefly switch off after the acquisi-
tion time, and if no code is decoded will switch on again
before the next acquisition. The illuminator will remain on
until the symbol is decoded.
As you read code symbols, adjust the distance at which
you are holding the reader.
Aiming System
A number of options for customizing control of the Aiming
System are available. See the QuickScan™ QBT/QM2500
PRG for more information and programming bar codes.
Good Read Green Spot Duration
Successful reading can be signaled by a good read green
spot. Use the bar codes that follow to specify the duration
of the good read pointer beam after a good read.
GOOD READ GREEN SPOT DURATION
ENTER/EXIT PROGRAMMING MODE
Disable
★ Short (300 ms)
To Next Page
Loading...
Need help?
General
