Cleaning Procedure
QUICK REFERENCE GUIDE
39
CLEANING PROCEDURE
Proper cleaning is needed on the external plastic surfaces,
output window and electrical contacts to guarantee reli-
able scanning and charging of the battery.
A regular cleaning routine will remove the dust and dirt
that may accumulate on the product over time. The main-
tenance activity may be repeated more frequently
depending on the severity of the environment in which
the scanner is used.
A periodic deeper cleaning is suggested once per month.
Cleaning plastic surfaces
A periodic deeper cleaning is suggested once per month.
Exterior surfaces and scan windows exposed to spills,
smudges or debris accumulation require periodic cleaning
to ensure best performance during scanning operations.
Follow the procedures described in this instruction sheet
to keep your QuickScan device in good operating condi-
tion.
Common Cleaning Solutions
The cleaners and disinfectants listed below are recom-
mended for use on Datalogic’s Quickscan QBT/QM2500
Enclosures:
WARNING: Be sure to turn off power and unplug
the device from electrical outlet before cleaning.
CAUTION: DO NOT use abrasive pads or cleaning
agents.
CLEANERS DISINFECTANTS
Formula 409® Glass and
Surface Cleaner
Clorox® Bleach (diluted 10:1)
70% Isopropyl Alcohol Hydrogen Peroxide 3%
Windex® Multi-Surface
100% Gentle dish soap
and water
To Next Page
Loading...
Need help?
General
