Datamax M-Class Mark II M-4206 User Manual

M-4206 43
5.6 Darkness Adjustment
The Darkness Adjustment allows the operator to match the print
contrast following a printhead replacement. Turning the Darkness
Adjustment clockwise will darken the print, while turning it
counterclockwise will lighten the print. Compare a label printed
with the old printhead and make this adjustment so that the new
printhead matches the darkest portion of that label.
; Note: Large increases in the ‘Darkness Adjustment’ can shorten
printhead life. If you need to increase the darkness of the
printed labels, try increasing the Heat value and/or slow the
Print Speed using your software program or via DPL
commands.
5.7 Resetting to the Factory Defaults
With the printer power ‘Off,’ press and hold all three buttons while turning ‘On’ the printer. Continue to hold the buttons
down until the
STOP
light turns off (approximately 17 seconds). The printer will now be set to the ‘Factory Defaults.’
See Section 4.5.1 for a listing of the factory default settings. Resetting to ‘Factory Defaults’ will not effect the following
settings:
5) SOP ADJUST 12) TOF GAIN
6) PRESENT ADJUST 13) TOF DELTA
11) OOS MAXVOLT 14) TOF LOW

Datamax M-Class Mark II M-4206 Specifications

General

Brand	Datamax
Model	M-Class Mark II M-4206
Category	Printer
Language	English