5
Loading Media
With the Peel and Present option, labels printed in a batch will be automatically be separated from the
backing material and dispensed “on-demand”– that is, printing will occur only after a previously printed
label has been removed from the printer.
Press in the Latch to open the mechanism.
Swing the mechanism open.
Load the printer with media (see the
Operator’s Manual for detailed instructions).
Latch
Load media into the printer as you normally
would for tear-off operation (see the
Operator’s Manual for details), however,
extend an additional 12 inches (30 cm) of
media out the front of the printer.
From this 12 inches (30 cm) of media, remove
all of the labels, so that only the Backing
Material remains.
Backing Material only
To Next Page
Loading...
Need help?
General
