13
Charging your Mobility Scooter
Charging your scooter is a simple process. You require the following:
• The charger that came with your Mobility Scooter.
• A household electrical outlet.
Charger Warning
Only use the chargers that were supplied with your mobility scooter. Using chargers that
do not have specicaons idencal to those which came with the mobility scooter could
irreparably damage your scooter’s baery and electrical systems, and may cause injury.
To charge your scooter, follow these steps:
1. Turn o the mobility and remove the key from the ignion (if applicable).
2. Plug the female end of the charger cable into the charging slot on the mobility
scooter.
3. Plug the male end of the charger power cable into your wall socket. This should
be a household electricity supply. You can also use a portable generator, if necessary..
4. Allow the mobility scooter baery to charge for the appropriate amount of me
(6-12 hours).
5. Disconnect the charger when the LED light on the charger is green. The baeries
have been fully charged.
If your charger’s LED status light does not change from red to green over an extended
period of me, for perhaps more than 14 hours, and the baery is very hot, the baery
or charger may need replacing. Stop charging and bring both to your Daymak dealer
immediately. Do not overcharge the baery.
To Next Page
Loading...
Need help?
General
