7/Tightening the seat
Removing or installing the wheel fixing system
-
loosen the quick fastener or nut (as for the wheel quick fastener).
-
turn the quick fastener lever from Closed to Open.
-
correctly position your seat in the tube.
-
turn the quick fastener lever from Open to Closed.
Never go beyond the insertion limit.
Warning :
The force should be sufficient to block your seat in.
Carefully read section I 1/
8/Fitting accessories: reflectors, bottle cage, stand, stabilisers
Advice: Our workshop is available to carry out any assembly in complete safety.
You will find inserts on your frame to fit a bottle cage.
For the stand, follow the diagram below.
Refer to the assembly instructions for stabilizers.
To Next Page
Loading...
Need help?
General