Dell EMC N3048EP-ON User Manual

Getting Started Guide 17
Example Session
This section describes a Dell EMC Easy Setup Wizard session. The following
values are used by the example session:
• The SNMP community string to be used is public .
• The network management system (NMS) IP address is
10.1.2.100 .
• The user name is
admin , and the password is admin123 .
• The OOB management interface uses
DHCP for IP address assignment.
• The IP address for the VLAN 1 routing interface is
10.1.1.200 with a
subnet mask of
255.255.255.0 .
• The default gateway is
10.1.1.1.
The setup wizard configures the initial values as defined above. After
completing the wizard, the switch is configured as follows:
• SNMPv2 is enabled and the community string is set up as defined above.
SNMPv3 is disabled by default.
• The admin user account is set up as defined.
• A network management system is configured. From the management
station, you can access the SNMP, HTTP, and CLI interfaces. You may also
choose to allow all IP addresses to access these management interfaces by
choosing the (0.0.0.0) IP address.
• DHCP is enabled on the OOB management interface.
• An IP address is configured for the VLAN 1 routing interface.
• A default gateway address is configured.
NOTE: In the following example, the possible user options or default values are
enclosed in [ ]. If you press <Enter> with no options defined, the default value is
accepted. Help text is in parentheses.

Dell EMC N3048EP-ON Specifications

General

Brand	Dell EMC
Model	N3048EP-ON
Category	Switch
Language	English