46
|
Operation
Identification
The identification screens display the following UPS information:
S Type and model
S Part number
S Serial number
S UPS firmware
S Network Management Card firmware
NOTE:
The NMC firmware screen displays only if the Network Management Card is installed. See “Dell
Network Management Card“ on page 58.
Settings
Only available options are displayed.
User settings are not protected by default. You can enable the password through the User Password
setting.
Table 7 displays the options that can be changed by the user.
Table 7. Settings
Description
Available Settings Default Setting
Change Language [English] [French] [German] [Spanish] [Japanese]
[Simplified Chinese] [Russian] [Korean]
[Traditional Chinese]
English
User Password [Enabled] [Disabled]
If Enabled, the default password is USER.
NOTE: If you enter an incorrect password, the
message “Wrong Password” appears. Press any
button to return to the password screen and retry
the password.
Disabled
Audible Alarms [Enabled] [Disabled]
NOTE: If you disable audible alarms, it takes effect
instantly and remains disabled, even after a power
cycle. This differs from the mute feature where the
horn is temporarily silenced on any button press,
but turns on again if a new alarm is triggered.
Enabled
To Next Page
Loading...
Need help?
General
