Dell 3115cn Color Laser Printer - Assign an IP Address

NOTE: When you assign an IP address manually in IPv6 Mode, use the Dell Printer Configuration
Web Tool. To open the Dell Printer Configuration Web Tool, use the link local address. (To check
a link local address, see "Print and Check the System Settings Page".)
An IP address is a unique number that consists of four sections that are delimited by a period and can
include up to three digits in each section, for example, 111.222.33.44.
Assigning an IP address already in use can cause network performance issues.
NOTE: Assigning an IP address is considered as an advanced function and is normally done by a
system administrator.
For more information on using your operator panel, see "Operator Panel".
Turn on the multifunction printer.1.
>COPY appears.
Press until >SETUP appears, and then press .2.
Press until >Admin Menu appears, and then press .3.
Press until >Wired Net or >Wireless Net appears, and then press .4.
Press until >TCP/IP appears, and then press .5.
Press until >IP Address appears, and then press .6.
The cursor is located at the first digit of the IP address. Press to enter the numbers for the IP
address.
7.
Press .8.
The cursor moves to the next digit.
Repeat steps 7 and 8 to enter all of the digits in the IP address, and then press .9.
Press the Back button.10.
Press until >Subnet Mask appears, and then press .11.
Repeat steps 7 to 8 to set Subnet Mask, and then press .12.
Press the Back button.13.
Press until >Gateway Address appears, and then press .14.
15.