Removing the touchpad
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the battery.
Procedure
1 Open the latch, and disconnect the touchpad cable from the system board.
2 Peel the tapes that secure the touchpad to the palm-rest and keyboard assembly.
3 Remove the three screws (M2x3) that secure the touchpad bracket to the palm-rest and keyboard assembly.
4 Lift the touchpad bracket o the palm-rest and keyboard assembly.
5 Remove the four screws (M2x2) that secure the touchpad to the palm-rest and keyboard assembly.
6 Lift the touchpad, along with the cable, at an angle from under the touch-pad bracket o the palm-rest and keyboard assembly.
36
60 Removing the touchpad