10
ANTI-TILT BRACKET
Important!
To restrain the appliance
and prevent it tipping acci-
dentally, fit a bracket to its
rear to fix it securely to
the wall. Make sure you
also fit the supplied lock
pin to the anti-tilt bracket.
To fit the anti-tilt bracket:
1. After you have located
where the cooker is to be
positioned, mark on the wall the
place where the two screws of
the anti-tilt bracket have to be fit-
ted. Please follow the indications
given in Fig. 8a.
2. Drill two 8 mm diameter holes in
the wall and insert the plastic
plugs supplied.
Important!
Before drilling the holes,
check that you will not dam-
age any pipes or electrical
wires.
3. Loosely attach the anti-tilt brack-
et with the two screws supplied.
4. Move the cooker to the wall and
adjust the height of the anti-tilt
bracket so that it can engage in
the slot on the cooker’s back, as
shown in Fig. 8a.
5. Tighten the screws attaching the
anti-tilt bracket.
6. Push the cooker against the wall
so that the anti-tilt bracket is fully
inserted in the slot on the cook-
er’s back.
7. Access the bracket and fit the
lock pin:
•Open the pivoting panel (Fig.
8b).
•Fit the lock pin through the
bracket, as shown (Fig. 8c).
•Close the pivoting pan
el.
To Next Page
Loading...
Need help?
General