3333
Figure 34 Figure 35
ELECTRONIC CLOCK (g. 33)
The programmer is equipped with an
electronic clock with illuminated numbers
which indicates hours and minutes.
Upon immediate connection of the oven or
after a power cut, three zeros will ash on
the programmer display.
To set the correct time of day it is necessary
to push the
button and then the or
button until you have set the correct
time (g. 33).
In another way push simultaneously the
two buttons and at the same time
push the or button.
Note: If the clock is reset it deletes any
previously set programs.
NORMAL COOKING WITHOUT THE
USE OF THE PROGRAMMER
To manually use the oven, without the
aid of the programmer, it is necessary to
cancel the ashing ‘AUTO’ by pushing the
button (‘AUTO’ will be switched off and
the symbol
will illuminate - g. 34).
Attention: If ‘AUTO’ is illuminated in the
programmer display (which means an
automatic or semi-automatic cooking
program has already been inserted), by
pushing the button you cancel the
program and return to manual operation.
If the oven is switched on, you must switch
off manually.
ELECTRONIC TIMER
The timer program consists only of a
buzzer which may be set for a maximum
period of 23 hours and 59 minutes.
If the ‘AUTO’ symbol is ashing push the
button.
To set the time, push the
button and then
the or until you obtain the desired
time in the display (g. 35).
Having nished the setting, the clock hour
will appear on the display and the
symbol will be illuminated.
The countdown will start immediately and
may be seen at any moment on the display
by simply pressing the button
.
At the end of the time, the
symbol will
disappear and a buzzer will sound and
continue for approximatley 7 minutes or
until a button is pressed (not the /
buttons). After a short time the display will
revert back to the time of day.
SETTING THE FREQUENCY OF THE
AUDIBLE SIGNAL
The buzzer has 3 different tones and can
be changed by pressing the button, but
only when the time of day is displayed
To Next Page
Loading...
Need help?
General