15
12.8 Cleaning the pre-ground coee funnel
Check regularly (about once a month) that the pre-ground
coee funnel (A4) is not blocked. If necessary, remove coee
deposits with the brush (D5) supplied.
12.9 Cleaning the infuser
The infuser (A20) must be cleaned at least once a month.
Important!
The infuser cannot be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see section
"5. Turning the appliance o");
2. Remove the water tank (A17) (g. 3);
3. Open the infuser door (A19) (g. 26) on the right side of
the appliance;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (g. 27);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID NO DISHWASHER
Clean the infuser without using washing up liquid as it could
be damaged.
6. Use the brush (D5) to remove any coee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the
internal support (g. 28), then push the PUSH symbol fully
in until it clicks into place;
Please note!
If the infuser is dicult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in g. 29.
8. Once inserted, make sure the two coloured buttons have
snapped out (g. 30);
9. Close the infuser door;
10. Put the water tank back.
12.10 Cleaning the milk container
To keep the frother ecient, clean the milk container every two
days as described below.
1. Remove the lid (E2);
2. Remove the milk spout (E5) and intake tube (E4) (g. 31);
3. Turn the froth adjustment dial (E1) anticlockwise to the
"INSERT" position (g. 31) and pull it o upwards;
4. Wash all the components thoroughly with hot water and
mild washing-up liquid. All components are dishwash-
er safe, but must be placed in the top basket of the
dishwasher. Make sure there are no milk residues on the
hollow and groove under the dial (g. 32). If necessary,
scrape the groove with a toothpick;
5. Rinse inside the froth
adjustment dial seat with
running water (g. 33);
6. Check that the intake
tube and spout are
not clogged with milk
residues;
7. Replace the dial (in cor-
respondence to the word
"INSERT"), spout and
milk intake tube;
8. Place the lid back on the
milk container (E2).
12.11 Cleaning the hot water nozzle
Each time you prepare milk, clean the connection nozzle (A8)
with a sponge to remove milk residues from the gaskets (g.
21).
13. DESCALING
Important!
• Before use, read the instructions and the labelling on the
descaler pack.
• It is important to use De’Longhi descaler only. Using un-
suitable descaler and/or performing descaling incorrectly
may result in faults not covered by the manufacturer's
guarantee.
Descale the appliance when "DESCALING NEEDED" "PRESS OK TO
START (~45min)" appears on the display: To descale immedi-
ately, press
and follow the operations from point 3.
To descale the appliance later, press . The
symbol appears on the display to remind you that the appliance
needs descaling. (The message appears each time you turn the
appliance on).
To access the descaling menu:
1. Pressthe "
" button (C3) to enter the menu;
2. Press "DESCALE" and follow the instructions on the
display;
3. "REMOVE WATER FILTER" (g. 34): extract the water tank
(A17), remove the water softener lter (D7) (if present)
and empty the water tank. Press
;
33
To Next Page
Loading...
Need help?
General
