8
2.4 Description of the accessories (page 2 - D)
D1. "Total Hardness Test" indicator paper (attached to page 2
of the English instructions)
D2. Pre-ground coee measure
D3. Descaler
D4. Water softener lter (certain models only)
D5. Cleaning brush
D6. Hot water spout
D7. Power cord
2.5 Description of the milk container (page 2 - E)
E1. Froth adjustment and CLEAN dial
E2. Milk container lid
E3. Milk container
E4. Milk intake tube
E5. Frothed milk spout (adjustable)
3. SETTING UP THE APPLIANCE
Please note!
• The rst time you use the machine, the water circuit is
empty and the appliance could be very noisy. The noise
becomes less as the circuit lls.
• Coee has been used to factory test the appliance and it
is therefore completely normal for there to be traces of
coee in the mill. The machine is, however, guaranteed to
be new.
• You should customise water hardness as soon as possible
following the instructions in section "14.
R Setting water
hardness".
1. Insert the power cable connector (D7) into the socket (A21)
at the back of the appliance and connect the appliance to
the mains electricity supply (g. 1). Make sure the main
switch (A22) at the back of the appliance is pressed (g. 2);
2. To select the language of the display, press and hold
until the required language appears on the
display, then press the ag corresponding to the language.
Follow the instructions indicated on the appliance display:
3. Remove the water tank (A17) (g. 3), ll to the MAX line
(marked on the tank) with fresh water (g. 4, then put the
tank back in the appliance (g. 5);
4. Check that the hot water spout (D6) is inserted on the con-
nection nozzle (A8) (g. 6) and place a container holding a
minimum of 100 ml underneath (g. 7);
5. Press
to conrm: The appliance delivers
water from the spout (g. 8) then goes o automatically.
The coee machine is now ready for normal use.
Please note!
• The rst time you use the appliance, you need to make 4
- 5 cappuccinos before it starts to give satisfactory results.
• When making the rst 4 - 5 cappuccinos, it is normal to
hear the noise of boiling water. After this, the noise be-
comes less.
• To improve the performance of your appliance, we recom-
mend installing a water softener lter (D7) as described
in section "15. nWater softener lter". If your model is not
provided with a lter, you can request one from De'Longhi
Customer Services.
4. TURNING THE APPLIANCE ON
Please note!
• Before turning the appliance on, make sure the main
switch (A22) is pressed (g. 2).
• Each time the appliance is turned on, it performs an auto-
matic preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this
cycle.
1. To turn the appliance on, press the
button (A15)
(g. 8);
2. When at temperature, the appliance performs a rinse cycle
delivering hot water from the coee spouts. As well as
heating the boiler, this also heats the internal circuits by
circulating hot water.
The appliance is ready for use when the main screen (home-
page) appears.
5. TURNING THE APPLIANCE OFF
Whenever the coee machine is turned o after being used to
make coee, it performs an automatic rinse cycle.
1. To turn the appliance o, press the
button (A15)
(g. 8).
2. T
he appliance performs a rinse cycle then goes o
(stand-by).
Please note!
If you will not be using the appliance for some time, unplug
from the mains socket:
1. First turn the appliance o by pressing the
button
(g. 8);
2. Release the main switch (A22) at the back of the appliance
(g. 2).
Important!
Never press the main switch while the appliance is on.