24
PROBLEM POSSIBLE CAUSE REMEDY
The coee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot
water (Please note: you can use the hot water
function).
The infuser has cooled down because
2/3 minutes have elapsed since the last
coee was made.
Before making the coee, heat the infuser by
rinsing using the rinse function
(see section
"6.3 Rinse "
"
).
A low coee temperature is set.
Set a higher coee temperature in the menu
(section "6.9 Coee temperature ").
Please note: Varying the temperature has
most eect for long beverages.
The coee is weak or not creamy
enough.
The coee is ground too coarsely. Turn the grinding adjustment dial (A5) one
click anticlockwise towards "1" while the cof-
fee mill is in operation (g. 13). Continue one
click at a time until the coee is made satisfac-
torily. The eect is only visible after delivering
2 coees (see section "7.5 Adjusting the coee
mill").
The coee is unsuitable. Use coee for espresso machines.
The coee is not fresh. The coee pack has been opened for too long
and has lost its taste.
The coee is delivered too slowly or a
drop at a time.
The coee is ground too nely. Turn the grinding adjustment dial (A5) one
click clockwise towards "7" while the coee
mill is in operation (g. 13). Continue one click
at a time until the coee is made satisfactori-
ly. The eect is only visible after delivering 2
coees (see section "7.5 Adjusting the coee
mill").
Coee does not come out of one or
both of the spouts.
The coee spouts (A9) are blocked. Clean the spouts with a toothpick (g. 25B).
The appliance will not make coee The appliance has detected impurities
in its internal circuits. "Cleaning under-
way" is displayed.
Wait for the appliance to be ready again and
reselect the required beverage. Contact Cus-
tomer Services if the problem persists.
The appliance does not come on The power cord connector (D7) is not
inserted correctly.
Insert the connector as far as it will go in the
socket at the back of the appliance
(g. 1)
.
It is not plugged into the mains socket. Plug into the mains socket (g. 1).
The main switch (A22) is not turned on. Press the main switch (g. 2).
18. TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.