22
18.1 Cleaning the inside of the coee machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned o
(see section “7. Turning the appliance o”) and unplugged from
the mains power supply. Never immerse the coee machine in
water.
1. Check regularly (about
once a month) that the
inside of the appliance
(accessible after removing
the drip tray, A14) is not
dirty. If necessary, remove
coee deposits with the
brush (C5) supplied and a
sponge.
2. Remove all the residues
with a vacuum cleaner
(g. 47).
18.2 Cleaning the water tank
1. Clean the water tank (A16) regularly (about once a month)
and whenever you replace the water softener lter (C4) (if
provided) with a damp cloth and a little mild washing up
liquid;
2. Remove the lter (if present) and rinse with running water;
3. Replace the lter (if provided), ll the tank with fresh water
and replace the tank;
4. (Models with water softener lter only) Deliver about
100ml of hot water to reactivate the lter.
18.3 Cleaning the coee spouts
1. Clean the coee spouts
(A8) regularly with a
sponge or cloth (g. 48A);
2. Check that the holes in
the coee spouts are not
blocked. If necessary, re-
move coee deposits with
a toothpick (g. 48B).
18.4 Cleaning the pre-ground coee funnel
Check regularly (about once a month) that the pre-ground cof-
fee funnel (A4) is not blocked. If necessary, remove coee depos-
its with the brush (C5) supplied.
18.5 Cleaning the infuser
The infuser (A19) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see “7. Turn-
ing the appliance o”);
2. Remove the water tank (A16) (g. 3);
49 50
PUSH
PUSH
3. Open the infuser door (A18) (g. 49) on the right side of
the appliance;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (g. 50);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID NO DISH WASHER
Clean the infuser without using washing up liquid as it could be
damaged.
6. Use the brush (C5) to remove any coee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the in-
ternal support (g. 51), then push the PUSH symbol fully in
until it clicks into place;