27
24. DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
FILL TANK WITH FRESH
WATER
Insucient water in the tank
(A16)
. Fill the tank with water and/or insert it correct-
ly, pushing it as far as it will go until it clicks
into place.
INSERT WATER TANK The tank
(A16)
is not correctly in place. Insert the tank correctly and press as far as it
will go.
EMPTY GROUNDS CONTAINER The grounds container (A10) is full.
Empty the grounds container and drip tray
(A14), clean and replace. Important: when
removing the drip tray, the grounds contain-
er must be emptied, even if it contains few
grounds. If this is not done, when you make the
next coees, the grounds container may ll up
more than expected and clog the machine.
INSERT GROUNDS CONTAINER After cleaning, the grounds container
(A10)
has
not been replaced.
Remove the drip tray (A14) and insert the
grounds container.
ADD PREGROUND COFFEE
MAXIMUM ONE MEASURE
The "pre-ground coee" function has been se-
lected without placing any pre-ground coee
in the funnel
(A4)
.
Place pre-ground coee in the funnel
(g. 14)
and repeat delivery
To Next Page
Loading...
Need help?
General
