button to cancel the operation);
6. Press the button to exit the menu.
Resetting factory default values
(reset)
This function resets the entire menu with the
default values (except the language, which
remains as set).
1. Press the P button to enter the menu;
2. Turn the selection knob until "Default Values"
is displayed;
3. Press the button;
4. The message "Confirm?" is displayed.
5. Press the button to confirm and exit
(or the button to cancel the opera-
tion);
Installing the filter
Certain models are provided with a water softener
filter (alternatively it can be purchased
separately from an authorised technical
assistance centre).
To install the filter, proceed as follows:
1. Insert the filter in the water tank as
far as it will go (see figure
alongside).
When you install the filter, you
must notify the appliance of its
presence.
2. Press the P button to enter
the menu;
3. Turn the selection knob until "Install Filter" is
displayed;
4. Press the button;
5. The message "Confirm?" is displayed.
6. Press the button to confirm (an aste-
risk appears at the top right of the display);
7. Press the button to exit the menu.
Replacing the filter ("Reset water
filter")
When the red light comes on, the filter must
be replaced:
1. Extract the exhausted filter and replace with a
new one;
2. Press the P button to enter the menu;
3. Turn the selection knob until "Reset Water
Filter" is displayed;
4. Press the button;
5. The message "Confirm?" is now displayed.
6. Press the button to confirm (or the
button to cancel the operation);
7. Press the button to exit the menu.
Removing the filter
If you want to use the appliance without a filter,
you must remove it and notify the appliance of its
removal as follows:
1. Press the P button to enter the menu;
2. Turn the selection knob until "Install Filter" is
displayed;
3. Press the button;
4. The message "Confirm?" is displayed.
5. Press the button;
6. When the asterisk has disappeared from the
top right of the display, press to exit
the menu.
Important! If this is not done, the appliance
could become clogged with limescale.
Important! If this is not done, the
appliance could become clogged with limescale.
Statistics function
1. Press the P button to enter the menu;
2. Turn the selection knob until "Statistics" is
displayed;
3. Press the button;
4. Turn the selection knob to verify:
- how many coffees have been made;
- how many cappuccinos have been made;
- how many times the machine has been desca-
led;
- the total number of litres of water run off;
- how many times the water filter has been
replaced.
5. Press the button twice to exit the
menu.
32
To Next Page
Loading...
Need help?
Power
Capacity
Weight and Dimensions
