6
automatically 40 minutes after coee delivery ends.
To turn the plate o press the button again.
button and restart .
Please note: removing the jug before all the coee re-
quested has been delivered does not interrupt coee making,
but merely blocks ow into the jug. If you want to pour out a
little coee immediately, you should do so as rapidly as possible
in order to avoid the coee overowing.
Cleaning and maintenance
Before maintenance or cleaning of the appliance, turn o, un-
plug from the mains socket and allow to cool.
-
fee maker. Just wipe with a soft damp cloth.
appliance.
Descaling
If the water in your area is hard, limescale builds up over time.
These deposits may aect correct operation of the appliance.
You are recommended to descale the coee maker every 60 cof-
fee making cycles. To descale, always use special commercially
available descaling products for drip coee makers.
1. Dilute the product in the jug, following the instructions on
the descaler pack;
2. Pour the solution into the water tank;
3. Place the jug on the warming plate;
4. Press the button, percolate the equivalent of one cup
then turn the appliance o;
5. Leave the solution to work for 15 minutes, then repeat op-
erations 4 and 5.
6. Turn the appliance on and deliver the water until the tank
is completely empty.
7. Rinse by operating the appliance with water only at least 3
Failure to clean as described above invalidates the guarantee.
Troubleshooting
Problem Probable cause Solution
The coee takes
longer to brew.
The coee maker
needs to be
descaled.
Descale the ma-
chine as described
in the section
DESCALING.
The coee has an
acidic taste.
Insucient
rinsing after
descaling.
Rinse the ma-
chine as described
in the section
DESCALING.
use
en
To Next Page
Loading...
Need help?
General
