DeLonghi MULTIFUNCTION BUILT-IN OVENS User Manual

31
REPLACING THE OVEN LAMP
WARNING: Ensure the appliance is switched off before replacing the lamp
to avoid the possibility of electric shock.
■ Let the oven cavity and the heating elements to cool down;
■ Switch off the electrical supply;
LEFT LAMP (models with electronic programmer only):
■ Remove the left wire rack and the side catalytic panel by unscrewing the fix-
ing screws (see chapter USING THE OVEN FOR THE FIRST TIME at page 12).
■ Press down from the top the protective cover A (fig. 29) and remove it by rotat-
ing on the lower side. IMPORTANT: never use screwdrivers or other utensils to
remove the cover A. This could damage the enamel of the oven or the lam-
pholder. Operate only by hands.
■ Unscrew and replace the bulb B with a new one suitable for high temperatures
(300°C) having the following specifications: 230-240V 50 Hz, 25W, E14.
■ Refit the protective cover A operating in reverse order. ATTENTION: the notch
in the inner edge of the cover must be oriented toward the lamp.
■ Assemble the side catalytic panel and the left wire rack.
TOP RIGHT LAMP (all models):
■ Remove the protective cover C (fig. 29);
■ Unscrew and replace the bulb B with a new one suitable for high temperatures
(300 °C) having the following specifications: 230-240V 50 Hz, (15 W for models
with cut-off timer and 25 W for models with electronic programmer), E14;
■ Refit the protective cover;
NOTE: Oven bulb replacement is not covered by your guarantee.
A
B
B
C
1
2
A
A
Figure 29
A
A
A
B
B
C
1
2

DeLonghi MULTIFUNCTION BUILT-IN OVENS Specifications

General

Brand	DeLonghi
Model	MULTIFUNCTION BUILT-IN OVENS
Category	Oven
Language	English