9
Operation
TURNING THE APPLIANCE ON
Plug the appliance into the mains. Two lines appear on the
display indicating that the appliance is in stand-by.
Press the button (A).
The first time the appliance is turned on, it will be in air conditio-
ning mode. Room temperature will be displayed and fan speed
will be at minimum. When turned on subsequently it will be in the
same mode as when last turned off.
Press the MODE button (B) until the symbol corresponding to the
required mode is displayed:
Air conditioning symbol (G)
Dehumidifying symbol (H)
Heating symbol (I)
Fan symbol (L)
AIR CONDITIONING MODE
Ideal for hot muggy weather when you need to cool and dehu-
midify the room.
To set this function correctly:
• Press the MODE button a number of times until the air condi-
tioning symbol appears. Room temperature is displayed.
• Select the target temperature by pressing the button (F) or
button (C) until the required value is displayed.
During selection, the temperature flashes.
After 10 seconds, room temperature is displayed again.
• Select the required fan speed by pressing the button.
There are 3 speeds available:
High speed: to achieve the target temperature as
rapidly as possible
Medium speed: reduces noise levels but still maintains a
good level of comfort
Low speed: for silent operation
The most suitable temperature for the room during the summer
varies from 75 to 81°F. You are recommended, however, not to
set a temperature much below the outdoor temperature.
DEHUMIDIFYING MODE
Ideal to reduce room humidity (spring and autumn, damp rooms,
rainy periods, etc). For this mode, the appliance should be prepa-
red in the same way as for air conditioning, with the air exhaust
hose attached to enable the moisture to be discharged outside.
To set this function correctly:
• Press the MODE button a number of times until the dehumi-
difying symbol appears.
To Next Page
Loading...
Need help?
General
