5
Preparing for use
en
ELECTRICAL CONNECTIONS
Beforepluggingtheapplianceintothetheelectricalreceptacle,
check that:
• The outlet’s power supply corresponds to the value
indicated on the rating label on the back of the appliance;
• The outlet and electrical circuit are adequate for the
appliance;
• Theoutletisa3-holegroundedoutlet.Ifthisisnot
the case, you must choose another outlet.
Failure to follow these important safety instructions
absolves the manufacturer of all liability.
The power cable must be replaced by a qualied
professional only.
The instructions below will enable you to prepare your air
conditioner for operation as eciently as possible.
Before use, make sure the air intake and outlet grilles
are unobstructed.
AIR-CONDITIONING WITHOUT INSTALLATION
Just a few simple steps and your comfort is ensured with your
air conditioner:
• Screwthehoseadaptor13tothehose’send 12.
• Fittheairexhausthoseinthehousingatthebackofthe
appliance. Insert it as shown in gure A.
• Screw the window outlet 17 to the other end of the
exhaust hose (see g. B).
Sash window
• Openthewindow.
• Placethewindowbracket 15 in the window, extending it
to t the width of the window (g. C).
• Place the air conditioner near the window. Insert the
assembled exhaust hose 12 into the window bracket hole
15.
• Makesuretheairexhausthoseisunobstructed.
• Ifyouhaveaverylargewindow,inordertocoveryour
window aperture, use the additional window bracket
without holes extending it to the desired dimension, then
x the bracket by using the locking pin provided. When
extractingthewindowbracketandjoiningthetwopieces
pay attention you do not cover the hole.
Other set-up methods:
• Thankstothelockingpin,it’spossibletousethewindow
bracket also for sliding windows. Position the hole of the
bracket so to allow a correct installation of the exhaust
hose (see gure D).
Keep the air hoses as short and free of curves as possible to
avoid constrictions.
1
2
A
B
C
D