EN INSTRUCTIONS AND MODE OF USE
104
TROUBLESHOOTING
PROBLEM SOLUTION
The equipment won’t switch on.
The control buttons don’t work.
Confirm whether the electrical plug
has been fitted into the respective
socket properly and whether the
On/O general button is appropriately
switched.
The lever doesn’t close
completely.
Check whether a capsule has been
retained inside the extraction unit.
Open and close the lever again until
observing that the extraction unit is
clear and unblocked.
The capsule gets stuck in the
capsule holder housing.
Check whether the used capsule
tank is full. Where necessary, empty
it and put the empty tank back in its
specified position.
Luminous alerts appear which are
not described in the manual.
Contact Customer Service
and Support
(00 800 20 50 20 50).
To Next Page
Loading...
Need help?
General
