Delta 31-460 User Manual

18
Fig. 47
SANDING INSIDE CURVES
Inside curves can be sanded on the top sanding drum, as shown in Fig. 47.
Fig. 48
SANDING OUTSIDE CURVES
Outside curves should be sanded on the sanding disc as shown in Fig. 48.
WARNING: ALWAYS SAND ON THE LEFT (DOWNWARD) SIDE OF THE SANDING DISC, AS SHOWN.
SANDING ON THE RIGHT (UPWARD) SIDE OF THE SANDING DISC COULD CAUSE THE WORKPIECE TO FLY
UP WHICH COULD BE HAZARDOUS.
WARNING: THE EDGE OF THE TABLE MUST BE POSITIONED A MAXIMUM OF 1/16 INCH AWAY FROM THE
SANDING DISC TO AVOID TRAPPING THE WORK OR FINGERS BETWEEN THE TABLE AND SANDING DISC.

Delta 31-460 Specifications

General

Brand	Delta
Model	31-460
Category	Sander
Language	English