111111
1. An ideal accessory for use with your miter saw is the
36-221 Work Clamp, shown at (A) Fig. 24.
2. Two holes (B) Fig. 25, are provided in the base of the
miter saw enabling you to use the clamp (A) on either the
right or left hand side of the saw blade.
WARNING: Keep hands out of path of saw blade.
If the workpiece you are cutting would cause your
hand to be within 4 inches of the saw blade, the
workpiece should be clamped in place before mak-
ing cut.
Fig. 24
Fig. 25
TYPICAL OPERATIONS AND HELPFUL HINTS
1. Before cutting, make certain the table is set at the correct angle and firmly locked in place.
2. Before cutting, determine that the workpiece is the right size for the saw.
3. Place the workpiece on the table and hold it firmly against the fence.
4. For best results cut at a slow, even cutting rate.
5. If the workpiece you are cutting causes your hand to be within 4 inches of the saw blade, the workpiece must be
clamped to the fence before cutting.
6. Never attempt any freehand cutting (wood that is not held firmly against the fence and table).
USING ACCESSORY 36-221 WORK CLAMP
A
A
B
To Next Page
Loading...
Need help?
General
