To Next Page

To Previous Page

BLADE GUARD AND

SPLITTER ASSEMBLY

DISCONNECT MACHINE FROM POWER

SOURCE.

1. Fasten the rear splitter mounting bracket (A) Fig. 29,

to the rear trunnion. Align the two holes in the rear

splitter mounting bracket with the two holes in the

trunnion. Place a 1/4" lock washer onto a 1/4-20x3/4"

hex head screw, place a 1/4" flat washer onto the hex

head screw, insert the hex head screw through the hole

in the rear splitter mounting bracket and thread the hex

head screw into the rear trunnion. Repeat this process

for the remaining hole. Do not completely tighten the

two screws (B) at this time.

2. Raise saw arbor to its highest position.

Fig. 29

Fig. 30

3. Remove screw and large washer (C) Fig. 30, from

the inside splitter mounting bracket.

4. Using a straight edge, check to see if the top and

bottom of the inside splitter bracket (D) Fig. 31, is

aligned with the inner arbor flange (E), as shown.

Fig. 31

Fig. 32

5. If alignment is necessary, loosen the two screws

(F) Fig. 32, align bracket (D) with the arbor flange and

tighten screws (F).

6. Loosely assemble large washer and screw (C) Fig. 32,

to the inside splitter bracket. This screw and washer was

removed in STEP 3.

Delta 36-650 User Manual

Questions and Answers: